Gamebird and Poultry producers realize that chicks must be kept warm or brooded during the first weeks of life. Surprisingly, improper brooding is one of the most common causes of stress.
Three basic methods are used to brood chicks.
The chicks have localized heat source and access to a cooler, unheated area. The chicks determine their own heating needs by moving from hot to cold areas and vice versa. This method is known as spot brooding.
A large area around the brooders is warmed to the same temperature when whole house brooding. The chicks have no choice between warm and cool areas.
Partial-house brooding--Partial-house brooding is much like whole house brooding, since the total brooding area is warmed. To save energy, however, the brooding area is reduced to the minimum amount needed for the size of chicks. As the chicks grow, the brooding area is increased in accordance to their sizes. Good ventilation is essential with all brooding systems but especially partial-house brooding.
Light the brooders 24 hours before the chicks hatch or arrive. Determine if the brooders are working properly, and adjust the temperature to 90 to 95 °F below the outer edge of the brooder (1 inch above the litter). In time of stress or vaccination reactions, increase brooder temperatures about 5 ° above the recommended temperature until the chicks recover.
Place an 18-inch-high, solid-type brooder guard around each brooder. Locate the guard 3 to 4 feet from the edge of the brooder. The guard prevents floor drafts and keeps chicks near the heat. In summer, enlarge the ring to keep chicks from getting too hot. Expand the guard a little each day (about 20 to 25 percent total area increase) until it is no longer needed after 7 to 14 days. You should reduce the temperature by 5 degrees a week until they can tolerate a normal outside temperature.
Corrugated cardboard makes an excellent brooder guard and can be discarded when it becomes soiled. In hot weather, hardware cloth or similar mesh material may be used instead of solid guard. Most of these guards are cleaned, disinfected, and reused.
Place an adequate number of feeders and waterers around each brooder. Provide at least two 1-gallon waterers and two 12-inch or 18-inch chick feeders for every 100 chicks. Feed placed on a few feeder lids or egg flats under each brooder encourages the chicks to start eating sooner.
Sprinkle a pile of feed on each lid before placing chicks under brooder. Remove lids when all feed is eaten or after 4 to 6 days. Do not use anything that is will become slippery if they walk on it.
Place long waterers or feeders in the brooding area, pointing toward the heat source. If placed parallel to the brooder guard, small chicks may be prevented from returning to the warmth. (At 1 day of age, they have not learned they sometimes have to go around a long object to get back to the warmth.) Placing feeders in a "wagon spoke" fashion also insures that a section of each feeder is always in a comfort zone. Locate the inner end of the feeder under or slightly outside the outer edge of the brooder or hover. Never place all the waterers and feeders directly under the brooder. The area under the brooder must be kept clear for brooding the chicks.
The day-old chick's temperature is about 3 °F below that of an adult's. Its body temperature starts rising about 4 days of age and reaches its maximum at 10 days. The chick needs time to develop temperature control (2 to 4 weeks). As the chick grows older, the downy coat is replaced with feathers, and brooder temperature must be reduced according to the temperature schedule. You should reduce the heat by 5 degrees per week until they can tolerate a normal outside temperature.
Important To Always Remember!
Brooding Gamebirds & Poultry